Austin95
Newbie
No I can’t see or feel nothing.can you feel anything that might be keeping it from sliding back on the top side of the trans?
You must be registered for see images attach
You must be registered for see images attach
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
No I can’t see or feel nothing.can you feel anything that might be keeping it from sliding back on the top side of the trans?
Ok will try that thanks for your helpHmm all i can think to do is try to start with a flat tipped pry bar and slowly tap it between the bellhousing and bloch to see if it will separate. try starting on one side and switch to the other and then switch back and forth till you get some movement. this should slowly walk it back. Just make sure that you have it supported some how so that if it lets loose it doesn't fall on you or fall and damage the trans.
I forgot about those. Maybe try spraying some sort of penetrating oil on them before you try the pry bar thing.The two dowel pins are probably siezed up.
95 rcsb, L33 5.3, hot cam, frost tune, 5spd, 4/6
Yea I have sprayed them for few days because was starting to think it might be those thanks for the helpI forgot about those. Maybe try spraying some sort of penetrating oil on them before you try the pry bar thing.
Yes thanks I already have the studs removed as it is 13mm and 15mmThe ones that you took nuts off of that held tabs and brackets. Those are actually bolts with a built in stud just for tabs and brackets to attach to, so after you pull the nut off and move the tab or bracket outta the way you will see the actual hex to remove the bolt/stud. Only thing I can think of off hand.
Sent from my SAMSUNG-SM-G891A using Tapatalk