Wouldn’t that be the only way?Yes, the fill plug on the side.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Wouldn’t that be the only way?Yes, the fill plug on the side.
Unless i was seeing things, theres a tube running from top of case then zip tied near left wheel and had a plug capped offWouldn’t that be the only way?
That would be the vent tube...Unless i was seeing things, theres a tube running from top of case then zip tied near left wheel and had a plug capped off
YesThanks, just fill it til it barely dribbles out rite?
Yep did that yesterday; i had painted the cab last yr but didnt get to fully do the backside.Maybe a simple one, but wash and wax the back of the cab. Years of road grime, rain, dirt, and whatever else has built up there and it normally can’t be cleaned as easily. A good wash/wax will go a long ways.
Currently have my bed off and reading this is a godsend as i'm about to blast the frame. I was wondering if you happen to know what kind of tap you use for it? I have mainly metric taps and might have a hard time sourcing one locallyMake sure that fuel pump ground is squeaky clean. It'll never be easier to reach. I like to run a tap through the bolt hole to clean the threads.