TommyJ1980
I'm Awesome
Bolts one and six in place on the driver (more difficult for me anyways) side with spreader, ready to put the gasket in, thank God almighty, we are making progress.
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Just realized I have no idea what to torque these to- anybody know off top of your head?
Heat the bolts/studs up cherry red and finger tighten them (ouch!) You can't loose with DormanI can't tell you what to torque that Dorman hardware to.
I bought an OEM brand puller today from autozone, that thing didnt pull ****, just fouled up the pulling lip and kept popping off. Guess i should have rentedI tried one like this but instead of the rod that slides into the hole in the middle of the pulley, it had a round knob that just butted up against it.
Prolly a few bad words too am I right.....Thanks again folks, finally got them on tonight. Lots of learning happened.
There may have been….Prolly a few bad words too am I right.....
I’m telling you, same thing happened to me! And yes, when I rented, I got the big nice set with all the options that worked great.I bought an OEM brand puller today from autozone, that thing didnt pull ****, just fouled up the pulling lip and kept popping off. Guess i should have rented