Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
That settles it, I'm jealous.Okay guys engine is all together, had a couple set backs but think it's lined out now. Flywheel and clutch fitment is good. Had to check the bellhousing runout and make sure it was within tremec's .005 clearance from center of the crank shaft. Also had to measure from bellhousing to fingers on the pressure plate to make sure i had proper clearance for the hydraulic throw out bearing. Also the fitment on the headers is more then tight, but I think I have that taken care of now too. Hope to get it in now and have headers bolted on too.
You must be registered for see images attach