BNielsen
I'm Awesome
You must be registered for see images attach
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Sounds like the position switch assembly if it's not the cluster. Could also be the wires between the switch body and the cluster... How did you tap them for the 0411?My gear selector light does not light up in OD/3/2/1; P/R/N light up just fine though. Could it be the selector on the transmission or something in the dash? It's not the cluster because the original did it, and my Esky cluster does it. Anyone dealt with this before?
How did you tap them for the 0411?
Sounds like the position switch assembly if it's not the cluster. Could also be the wires between the switch body and the cluster... How did you tap them for the 0411?
Brody, I'd check the connector at the trans and make sure it's clean or at least has a good connection.
I don't believe you need to tap them anymore, or at least on some. I recall Brody saying something about it at some point, but I can't remember. I didn't have to tap into the harness.
I didn't tap my wires, I used a .cax file with EFILive. Brody the CASE relearn literally takes a second, it's over the instant you crack the gas.
Regarding the trans range switch; Lextech programmed my PCM to not need it. Someone said it could possibly be the ribbon cable between the cluster and connector, I'll inspect that connector tomorrow to see.
That's weird, mine has never gone past 4000 for a CASE I don't think.
I've got to switch over something in the tune, @Mangonesailor noted that because of my modified rev limiter, it's kicking out of the CASE relearn for some reason, I can't remember if he said the specific issue.
That's weird, mine has never gone past 4000 for a CASE I don't think.
While that's true, you will bounce off the hard-coded rev-limiter for days and will never actually perform a Case relearn if it's not set to factory.
Believe me. I got to listen to my truck backfiring in a shop bay for a good 15min on and off while a guy tried (and was successful before). I put the rev limiters back and he did it in one shot.
Be that as it may, Brody, I think I sent you a tune ready-to-go so hopefully it'll go smoothly.