I took a few days off of work because i thought I had gotten Covid again. While I waited for my test results, which ended up being negative, i decided to get some work done on the Burb. I wanted to hook up my 600 watt Sub box, but could not figure where the wires off the Amp were coming from. All the wires were actually running to each individual door speaker. Ok no big deal, i'll just unhook them...nope! Whoever did the wiring cut the harness to add the wires from the amp. I connected and soldered the original connection on one door and no sound. Said fck it, i'm going to rip out this amp and put a better one I have laying around. With the radio out, it was clear that whoever did the job was an absolute hack. Pictures speak for itself. Sticky electrical tape and all... a bunch of cut wires etc etc it was a nightmare. The icing on the cake was that yellow wire running into the fuse panel on the drivers side dash being held in place by a 10 amp fuse. I got a good laugh out of that.
You must be registered for see images attach
All that I got
You must be registered for see images attach
So I removed the Kenwood unit from my Land Cruiser, and that is going to go into this. Ordered new harnesses and anything else I think I needed. I should have it wrapped up by Sunday. And I will have to fix the rest of the door speakers. The rear two are original BOSE i beleive, with the fronts being some Kenwoods but they didn't work to begin with. I am probaly going to source some original BOSE ones for the front.