deven bullis
Employed by the big blue hexagon
Another update: put in a new brake switch, problem still persists, leading me to think one of the communication wires from the abs module to the pcm has gone bad, suggestions?
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
What scan tool are you using? Does it communicate with the ABS and the transmission?My 4l60E wont shift into OD/cruise disabled when my ABS light is on, but the problem is I have no codes for the abs system. When the ABS light is off OD and cruise control works, usually when the truck is cold, if its warm the ABS light turns on, leading me to think a bad abs module or wire somewhere in the system. I haven't seen a post where someone has had this problem before so I'm pretty lost.
I’m using a Launch Millennium 90 Pro, I’ve never used it before to read abs codes on my truck but it reads abs codes on my dads 99 Tahoe, and this scan tool does read transmission data, the pcm commands 4th gear and the pcm believes im in 4th gear after the commandWhat scan tool are you using? Does it communicate with the ABS and the transmission?
Check out the data stream on the ABS. While you're in there, look for pending and history codes, too.I’m using a Launch Millennium 90 Pro, I’ve never used it before to read abs codes on my truck but it reads abs codes on my dads 99 Tahoe,
Do you have input shaft speed vs. output shaft speed? Do the two speed sensors indicate that the trans is/is not in OD?and this scan tool does read transmission data, the pcm commands 4th gear and the pcm believes im in 4th gear after the command