Recent content by dzynda

  1. D

    ‘95 cab and chassis donor for ‘97

    Have you found much information or is there another thread on this? I have a 97 ecsb 2500 454 no third door, the interior including dash wiring everything good but the cab is very rotten. I just found an 88-94 extended cab in good shape for $250 cab only and wondering if it will work for my 97...
  2. D

    OEM Keyless entry Retrofit

    Any headway on this topic? I just started cleaning up my 97 k2500 454 extended cab short bed 4 wheel drive. I had an extra fob tried putting it into program mode and it wouldn't. Which lead me to researching this and what the crap is AU3 code. Why would gm put power locks on a vehicle and then...
  3. D

    How to bag that truck of yours

    Ridetech has great stuff which is why they are expensive. I was looking at that rear kit for my truck but they told me it wasn't for 1 ton dually or not even though they have a 14 bolt option on the center link bracket. I assume those rear air shocks won't handle any kind of load.
  4. D

    The Member Truck Thread

    That sounds right, like I said the guy had a real attitude obviously had enough business. I'd rather drive an hour away to go to another store that they don't own. Thanks
  5. D

    Valve seals

    I have done the heads on one of my other ones and I noticed that there is no adjustment. I bought comp cams roller tip rockers and the stud kit for it but was advised not to use them so I just put the stock ones back on it. I also noticed the push rods were somewhat clogged so I cleaned them...
  6. D

    Valve seals

    Hey guys, I'm going to attempt this on my 2000 obs 454 1 ton. I assume there is not any different procedure then the 350? Should I consider changing the springs also? The truck has nearly 300,000 miles, I have no history on the truck like engine replacement etc. other than carfax. It always...
  7. D

    How to bag that truck of yours

    I have a few more tanks and pumps so I'll add another set. I'm using 3/8 dot fittings and plastic tube, do you use a water trap or drier?
  8. D

    Start then stall

    Mainly tire size calibration I run 33's, speed limiter delete, would like a performance or tow tune I have new heads with minor mods headers, dual 3" pipe in single 4" out exhaust, 85mm throttle body, cold air intake, trying to get an msd coil on plug ignition system to work and was thinking...
  9. D

    How to bag that truck of yours

    Well I got one of my accuair 5 gallon tank, pump,4 valve set up. I definitely need at least two 5 gallon tanks and pumps. With the psi and air volume needed to lift the heavy front end I have to let it build up again to fully raise it. I obviously won't be running it at that height and need to...
  10. D

    The Member Truck Thread

    Your visor give a lot of highway wind noise? I like them but only noise I like is radio and a little rumble.
  11. D

    The Member Truck Thread

    May I ask how much your line X cost? I brought my long bed into a local line X shop here in Knoxville and they told me like 2 grand. I thought they were just being D bags
  12. D

    The Member Truck Thread

    Karen?
  13. D

    Start then stall

    The truck seems to have some parasitic drain it is a 2018 battery and it's probably sat a year. Although whenever I change the battery with those side terminals and air box in the way if I don't get a solid connection and it clicks a couple times that will put it in security mode also.
  14. D

    Start then stall

    OK thank you, I figured not. I was torn between Jet and hypertech when I bought my first turner for my 97. I bought a hypertech and was happy with it. Sounds like HP or black bear performance would be the best? I do not have any tuning knowledge.
  15. D

    Start then stall

    I tried the turn to on position wait 10 minutes off for 30 seconds like 5 times and it didn't work. This link has 3 different procedures and the turn on to start then release the key to the on position (basically let it die) leave it for 10 or 11 minutes unit the security light goes off (in my...
See more

Latest posts

Staff online

Members online

... and 9 more.
Total: 1,692 (members: 59, guests: 1,633)

Forum statistics

Threads
64,358
Messages
1,392,077
Members
51,485
Latest member
DonnieBhn

Share this page

Top