You have an ls engine correct?
If so, its not a good idea to run a sbc clutch with that setup.
Better to use a clutch set from a ls truck that had a manual trans.
I used luk 04201 clutch set from rockauto behind my mild build 6.0L
I also used nfw1050 flywheel.
I still have it, it has been off the road for a few years. Engine bay is empty, waiting to finish my garage then I have a 6.0L with a few upgrades I'll be swapping in.
I can tell you what not to get if you are worried about drone lol the Super 44, even though it sounds great! I think you're on the right track with a Flowmaster 50.
Haven't done much to it since then, busy getting stuff in order to build our house.
I'm trying to find the time to build bumpers, I have a a sheet of 3/16" that keeps staring at me. I also modified a stock FPR to make it adjustable, hoping to put that in to see if it makes a diffrence.
Other...
Has anybody ever ran a snow plow with a SAS truck? I'll be building a house next year on an long access road that i'll have to maintain. I would rather make my truck more useful and plow with it instead of buying a plow truck. The welder will have to come out.
Just wondering if anybody has...
I did the same thing on my case from a 90's full size blazer (only difference being passenger drop). You seem to have everything covered. check the chain for slack, its cheaper in the long run to buy a complete kit with bearings, seals and chain if its loose.
got a new crossmember with skid plate made. 2x2x1/4" and some 3/16" reinforcement plating
Rock sliders/steps all done. 2"x3" 0.120" wall for the sliders, 2"x2"x3/16" for the legs, 1/4"x4" for the mounting plates and 1.5" sch40 pipe for the steps, angled up @ 15*
The steps were primered and...
Anyone run one of these on their truck? I am looking in to one but I want to know if they helped much? The kits i've seen on WFO concepts and TMR custom are for axle tube mounting. I'm wondering if anyone has done a diff mounted one since i have barely any room with the fuel tank on one side and...