Wheel spacers

[JollyGreen]

Absolutely. I might have some stock left over from another job I did. I think it's either 2" or 2.5" sheet. I'll PM you between tomorrow and Saturday. You want 2", right?

 

[Rewind]

I was thinking 4

Sent from my padded cell using Tapatalk 2

 

[Rewind]

Which should I go with, 1.5" or 2"

Sent from my padded cell using Tapatalk 2

 

[Rewind]

Bump!!

 

[am92]

Id go with 1.5" on my wheels, but mine already stick out a bit more than stock...since you're on NBS stock wheels idk...usually the fronts stick out a little more than the back though so you could go with 1.5 front and 2" rears to match

 

[Rewind]

Hummmmm........hadn't thought of that.

 

[am92]

I didnt know that either until I put on wheels with more offset and then I could tell that the fronts stuck out just a little more than the rears

 

[Rewind]

When I get off of work I'll check mine out and see.

 

[am92]

Here's some pics of mine to show what I mean...like I said it was hard to tell with stock wheels but with these others its easier to see. Its not a huge difference and it may just be the way the fenders are shaped but it makes it look like the fronts stick out more

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

Back

You must be registered for see images attach

Front

You must be registered for see images attach

 

[Rewind]

That's interesting. Have you measured the width to see if it's diff?