fjr1320
Newbie
I was wondering what you guys thought I should do in regards to the front axle for a sas on a 92 K1500. I'm looking for the cheaper way of going about it and i was wanting to get the ford hp dana 60 so i could just use the transfer case that's already in it but its hard to come by around here for less than $1000-1500 and I'm a poor architect student. I was also wondering if it would be any easier to find a chevy dana 60 (much easier to find around here) and just have the axle tubes pressed out and swapped so i could have the drivers side drop? I would just rather say away from a passenger side drop so i dont have to swap/clock the transfer case and then figure out the linkage to make my floor shifter work.