Been working a lot lately between my normal job and cutting/selling firewood, so haven't made much headway on the truck, but today a big problem came up. Early this year I got a crack in one of the plastic tanks on my radiator, and I repaired it with jb weld with intentions of getting a new one soon after, but never did. I was hauling a load of wood last week and I got the smell of antifreeze and the truck started to warm up so I pulled over and my jb weld fix had blown out, so I topped it off and drove home (never actually over heated) and went to the bone yard to get a used one. (I was wanting to wait to buy a aluminum tank one at tax time) put it in and ran it for a day and the truck forced a ton of water into the resivoir tank, got hot, and then the radiator cracked in the same spot as the last one, all at once... So I went to the parts store and bought a new one, put it in and that's where got bad. I've got bubbling coolant in the radiator, it's building up pressure (I'm guessing that's why the patch on my old one blew) and the starts burning the coolant. Now this all says head gasket to me except I'm getting steam out of both pipes (I have true duals) and that to me says intake. I'm not sure if a intake gasket can cause the bubbling and im not finding much searching so I may move this to the engines section but regardless I'm doing a compression test tomorrow before I start tearing it apart.
Sent from my iPhone using Tapatalk