JFISHTHECREATOR
Newbie
- Joined
- Oct 20, 2014
- Messages
- 32
- Reaction score
- 3
Picked up a 1993 Cheyenne 2wd for $1200. Has 350 tbi , 4l60e , and 263,000 miles. Gray exterior , tan interior.
currently in my school shop for repairs(by me of course) - used trans (4l60e 123K miles), windshield wiper motor(used), gauge cluster (123k), remove cat convertor - 3" pipe to thrush glass pack.
when I bought I knew it had certain issues, however did not know the trans was on its way out. It drove fine for a month , then I no longer had third or fourth gear. Before the trans took a dump , the exhaust rusted through and fell off. While on a long drive in the rain , my wiper motor decided to go out. And to top it all off, the gauge cluster only has one working gauge, the speedometer(non tach model).
I have the new trans mounted into the truck , drive shaft in (new rear u-joint) , and the new cluster in. I replaced the filter in the trans , and i blew the old fluid out of the cooler lines. I hope to have the truck ready to go sometime this week , and whenever it's out I will take pictures.
If there is any reason as to gauges not working let me know, I will be checking grounds and fuses tomorrow.
currently in my school shop for repairs(by me of course) - used trans (4l60e 123K miles), windshield wiper motor(used), gauge cluster (123k), remove cat convertor - 3" pipe to thrush glass pack.
when I bought I knew it had certain issues, however did not know the trans was on its way out. It drove fine for a month , then I no longer had third or fourth gear. Before the trans took a dump , the exhaust rusted through and fell off. While on a long drive in the rain , my wiper motor decided to go out. And to top it all off, the gauge cluster only has one working gauge, the speedometer(non tach model).
I have the new trans mounted into the truck , drive shaft in (new rear u-joint) , and the new cluster in. I replaced the filter in the trans , and i blew the old fluid out of the cooler lines. I hope to have the truck ready to go sometime this week , and whenever it's out I will take pictures.
If there is any reason as to gauges not working let me know, I will be checking grounds and fuses tomorrow.