Ju1cE
Newbie
*fixed - previous hack spliced 1/4 to 3/16 in the run to the rear. Will be replaced w full run of 1/4.
Hey GMT400 Forum,
I’m new to the platform and new to the platform but am not new to wrenching.
I just bought a 1990 K1500 Sport that had been hacked on by previous owner and questionable mechanics. I’m running new brake lines through the whole truck (replacing some poorly replaced lines) but am confused about the rear line. It comes out of the proportioning valve as 1/4 but the attached to the rear hose as a 3/16. I’m imagining something else had been in line before but is now missing since the last guy under here was a hack (pic below)
Guidance is appreciated!!
Yes that’s a plumbing tee, adapters and cap screw and yes it leaked haha
Hey GMT400 Forum,
I’m new to the platform and new to the platform but am not new to wrenching.
I just bought a 1990 K1500 Sport that had been hacked on by previous owner and questionable mechanics. I’m running new brake lines through the whole truck (replacing some poorly replaced lines) but am confused about the rear line. It comes out of the proportioning valve as 1/4 but the attached to the rear hose as a 3/16. I’m imagining something else had been in line before but is now missing since the last guy under here was a hack (pic below)
Guidance is appreciated!!
You must be registered for see images attach
Yes that’s a plumbing tee, adapters and cap screw and yes it leaked haha
Last edited: