Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I used ssbc. I pulled my axles and put possi in at the same time. Super simple install. Replace axle seals if you pull axles.
I would definitely check out doing the Jeep XJ intermediate shaft mod. I've done it and it helped the slop out some, cheap and easy to do and it looks good. I've still got slop though and all my front end parts are new as well. Maybe I'll look into gearbox being bad even though its new. I've got a 91 c1500, I don't believe I have any of the EVO stuff ya'll are talking about. I'll have to play with it more when I can get it back on some jack stands.
https://www.gmt400.com/threads/project-daily-driver.37861/
Link to build above.
You must be registered for see images attach
You must be registered for see images attach
I didn’t see it in your build thread. But did you have too or did you change the master cylinder for the rear disc? @Dubs
did you get e-brake kit?Yep. Little shop mfg sells an affordable, easy kit to install.
https://www.littleshopmfg.com/
Only real hassle is cutting the drum backing plate off but its really not too bad.