Custom hangers?

[chevyman("]

Is it possible to take the rivets off the hangers and move them up am drill new holes with bolts?

Sent from my LG-LS840 using Tapatalk 2

 

[bow61509]

anything is "possible" but drop hangers are relatively cheap and then you know it's done right. and it's pretty much the same amount of work. imo

sent from the c1500 Denali

 

[sewlow]

X2^^^!

 

[chevyman("]

Ok lol how much drop do they give about 2" or so

Sent from my LG-LS840 using Tapatalk 2

 

[sewlow]

1" or 2" depending on which hole that you mount the springs in. The come with the 2 positions already drilled.

http://www.canuckmotorsports.com/images/products/blue/truck/shackles_lg.jpg

http://www.canuckmotorsports.com/cat_chevygmc_lower-lg.html#2105

$49.95 CDN.

 

[chevyman("]

I have shackles already lol I need hangers now the shackles weren't enough after the roll pan install

Sent from my LG-LS840 using Tapatalk 2

 

[sewlow]

Have fun with the driver's side hanger! A major PITA!!! Super tight fit between the tank & frame. You'll need REALLY small hands to get the bolts in there.
Easier with the bed off, the tank out, or if the GF has small hands.

 

[sewlow]

Have your pinion angle checked after the install. With a flip kit, the angle is predetermined, but not so with the shackle/hanger's. My '97 required a 1.5deg. shim. Some trucks need more, some none at all.

 

[chevyman("]

where would the shim go to change pinion angle?

Sent from my LG-LS840 using Tapatalk 2

 

[bow61509]

where would the shim go to change pinion angle?

Sent from my LG-LS840 using Tapatalk 2

between the rear end and leaf springs

sent from the c1500 Denali