mdnky
DOH!
03.16.2023 (cont...cont...cont...cont...)
Pulled the fuel supply line from the filter back to measure and build the replacement. I originally planned on using the bubble flare of the quick connect piece, but decided it was more hassle than it was worth. Also wasn't 100% sure it'd seal properly under pressure, not to mention nylon tubing is a royal pain to try and squeeze over that.
Ended up using a 10mm (3/8) nylon to steel compression fitting [$14.24 5-pack] instead. Just lopped off a bit more of the fitting first. Other end got a M16x1.5 female barb. Heated the hose in some n to quite boiling water for about 30 seconds and it slid on relatively easily. Stopped after this and I an out of light and decent weather.
RUNNING TOTAL: $4574.97
Pulled the fuel supply line from the filter back to measure and build the replacement. I originally planned on using the bubble flare of the quick connect piece, but decided it was more hassle than it was worth. Also wasn't 100% sure it'd seal properly under pressure, not to mention nylon tubing is a royal pain to try and squeeze over that.
Ended up using a 10mm (3/8) nylon to steel compression fitting [$14.24 5-pack] instead. Just lopped off a bit more of the fitting first. Other end got a M16x1.5 female barb. Heated the hose in some n to quite boiling water for about 30 seconds and it slid on relatively easily. Stopped after this and I an out of light and decent weather.
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
RUNNING TOTAL: $4574.97
Last edited: