Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Down pipes: driver side snaked over shaft! Lift kit, 6 inch k2500 kit + 3 inch BL has tons of room- in RC pics /installation instructions pipe goes around and down below driveshaft. My local shop wanted to keep out of rocks, etc. They used 2.5 I believe. Pass side used mandrel bent piece from JBA, driver side used mandrel bent to o2 sensor then bent pipe. new u joints on front driveshaft too:
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Small update: plug wires back on. Motor running! No major issues with studs or EGR parts! Pics to come soon as weather has been wet and cold.
What’s the butt dyno tell you? Any noticeable improvement?
Looks like a nice clean install! Glad it went well!
What lift is that? RC? Did you do blocks/springs/shackle flip in the back?