4 hi mod no worky

[bowtie-till-i-die]

Okay I'm moving over here so I don't monopolies the sticky thread. I did the 4 hi mod and it's like I didn't do anything at all. I put the relay next to battery, ran power from battery to prong 30, with an inline 30 amp fuse.
then a ran from the battery neggative to prong 85 on the relay.
then from 86 to the tan on the lows
and finaly prong 87 to the green wire on the higths
volts are good at every conection, i have the big 3 mod. any help is appreciated
this is a 98 with hids on the lows.

 

[loud00chevy]

Did 4hi mid last weekend on my 90 model, same results as you lol, have done it on another truck,2000 model, I had and it worked so idk what I did wrong....in for help

 

[slippy3002]

87 hours to the low beam
86 goes to the high beam

Sent from Robl@nd

 

[slippy3002]

You must be registered for see images attach

Sent from Robl@nd

 

[magimerlin]

^^ You have no trigger for the relay in the above pic...

I take that back.... I use negative triggers for all my relays usually....I looked to fast at it...

sent from what use to be a great country..

 

[magimerlin]

Or is that a stick figure with shoes on.............. j/k.....that the first thing I thought of when I saw the pic....lol

sent from what use to be a great country..

 

[loud00chevy]

Lol....now all I see is a stick figure with shoes when I look at...thanks for the help, I'll try to get around to checking it this week or weekend

 

[magimerlin]

Yup 86 on your relay is your input signal and needs to go to your high bean wire...

87 is you output signal from the relay and needs to go to your low beams..

85 goes to ground

30 should be a 12 volt fused from the battery

sent from what use to be a great country..

 

[slippy3002]

thanks now I see a stick figure with shoes!

Raising the roof none the less.

Sent from Robl@nd

 

[slippy3002]

^^ You have no trigger for the relay in the above pic...

I take that back.... I use negative triggers for all my relays usually....I looked to fast at it...

sent from what use to be a great country..

Yup 86 on your relay is your input signal and needs to go to your high bean wire...

87 is you output signal from the relay and needs to go to your low beams..

85 goes to ground

30 should be a 12 volt fused from the battery

sent from what use to be a great country..

It was a half a$$ drawing to show where the wires go.

Sent from Robl@nd