HotWheelsBurban
Gotta have 4 doors..... Rawhide, TOTY 2023!
I like the two tone grille, gorgeous dually!Think I'll just leave it like this...
You must be registered for see images attach
You must be registered for see images attach
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
I like the two tone grille, gorgeous dually!Think I'll just leave it like this...
You must be registered for see images attach
You must be registered for see images attach
To light the truck on fire with???Boooo!!!! Do you have a torch?
They can be a little off center, as long as they don't bend. That'll blow out the side.Does having your helper bag not perfectly aligned top to bottom negatively impact performance at all?
She’s looking good!!!
I was worried about it too but it's in line on the ground, so it should be fine. I have the lower bracket an bag mounted all the way to the rear so there's not much else I can do about it. They look normal under load. I'll take another picture to ease everyones mind though....They can be a little off center, as long as they don't bend. That'll blow out the side.
To heat the inner race before slamming it on the spindle.To light the truck on fire with???
Not going to work so well with it packed full of grease, in the rotor an not melting the seal...To heat the inner race before slamming it on the spindle.
Not going to work so well with it packed full of grease, in the rotor an not melting the seal...
Plus you gain a few thousandths when heating one to install it. I need .6, even glowing red hot it won't expand that much. I'm not sure what brand bearing these are but most only recommend about 250-275* if you heat them for install. More than that can damage them an severely shorten the life span.