FastOrange
OBSless
Been putting this off for a LONG time, Truck has to go, i need a 4x4 for winter.
Here is the specs
1500 Km on rebuilt 350 with ~350FWHP
Engine/Tranny Specs:
1988 TBI 350 Short Block, 4-Bolt Main, Fully Machined for Roller and Fuel Pump.
1998 906 Vortec Heads, Upgraded with Comp Springs, Retainers, Locks, Fel-Pro Seals
Scorpion Performance Self-Aligning Full Roller Rockers
Comp ***** Thumr Flat-Tappet Cam
Comp Lifters
Comp Pushrods
Double Roller Timing Chain
Edelbrock Performer RPM Vortec
1" 4-Hole Spacer
BRAND NEW 670CFM Holley Street Avenger
MSD StreetFire HEI Unit, Upgraded with advanced Curve kit, MSD HEI Coil and MSD Module
Taylor 8MM Spiro Pros
NGK TR55 Spark Plugs
Flowtech Short Headers
Flowmaster 40 SIDO, Dumped just after cab.
4L60E GoodWrench Replacement Being ran Via stock PCM and a Holley TPS kit on the Carb
2200 Stall
Fresh Flush/Fluid
Chassis
Lowered 4/7 Via Spindles/Springs up front, and Flipkit and shackles in rear,
Front has NitroDrop 2 shocks, Rear has 1 year old DJM Cal-Maxs,
resting on 20" Platinum Warlords
Body/Interior:
Shaved Antenna, Stake pockets, rollpan, tailgate
Tangerine Pearl Paint
VERY little rust, just some VERY minor bubbling, a couple small dents here and there
1988/89 low back buckets
10" Clarion sub
Pioneer 300W amp Carver 50W powering 6.5"s in the door
Pioneer tweets in vents
Alpine S 6x4's in rear
Pioneer 6x4's in front
Alpine Deck
Autometer Oil PSI Gauge Electric
Equus Coolant gauge (Mech.)
Autometer Lunar tach (10,000 RPM) with shift light.
Truck drives and handles like a dream, new engine runs awesome and sounds great.
Truck was in Street Truck Magazine, Has one numerous awards at shows.
Looking for $7800 CAD or trades for a Newish 4x4
Here is the specs
1500 Km on rebuilt 350 with ~350FWHP
Engine/Tranny Specs:
1988 TBI 350 Short Block, 4-Bolt Main, Fully Machined for Roller and Fuel Pump.
1998 906 Vortec Heads, Upgraded with Comp Springs, Retainers, Locks, Fel-Pro Seals
Scorpion Performance Self-Aligning Full Roller Rockers
Comp ***** Thumr Flat-Tappet Cam
Comp Lifters
Comp Pushrods
Double Roller Timing Chain
Edelbrock Performer RPM Vortec
1" 4-Hole Spacer
BRAND NEW 670CFM Holley Street Avenger
MSD StreetFire HEI Unit, Upgraded with advanced Curve kit, MSD HEI Coil and MSD Module
Taylor 8MM Spiro Pros
NGK TR55 Spark Plugs
Flowtech Short Headers
Flowmaster 40 SIDO, Dumped just after cab.
4L60E GoodWrench Replacement Being ran Via stock PCM and a Holley TPS kit on the Carb
2200 Stall
Fresh Flush/Fluid
Chassis
Lowered 4/7 Via Spindles/Springs up front, and Flipkit and shackles in rear,
Front has NitroDrop 2 shocks, Rear has 1 year old DJM Cal-Maxs,
resting on 20" Platinum Warlords
Body/Interior:
Shaved Antenna, Stake pockets, rollpan, tailgate
Tangerine Pearl Paint
VERY little rust, just some VERY minor bubbling, a couple small dents here and there
1988/89 low back buckets
10" Clarion sub
Pioneer 300W amp Carver 50W powering 6.5"s in the door
Pioneer tweets in vents
Alpine S 6x4's in rear
Pioneer 6x4's in front
Alpine Deck
Autometer Oil PSI Gauge Electric
Equus Coolant gauge (Mech.)
Autometer Lunar tach (10,000 RPM) with shift light.
Truck drives and handles like a dream, new engine runs awesome and sounds great.
Truck was in Street Truck Magazine, Has one numerous awards at shows.
Looking for $7800 CAD or trades for a Newish 4x4
You must be registered for see images attach
You must be registered for see images attach
Last edited: