Search results

  1. R

    accelleration lag?

    I found a bad coil in my searches so I replaced that, lag was still occurring. I checked the timing and it was fairly advanced so I retarded it, but I forgot to unplug the connector by the fuel pump relay (I had no clue this even existed). since I didn't unplug the connector, I was fighting the...
  2. R

    accelleration lag?

    I replaced the tps (it was destroyed). I recently rebuilt the engine and transmission so those are new. the timing is not fine tuned so I will do that this weekend. fuel is fine, I know that much. I will check the timing and fine tune it and see what happens. thanks for the list!
  3. R

    accelleration lag?

    when I accelerate in my truck, only at lower speeds and when engine is warm, there seems to be an "acceleration lag" like symptom. when I press on the gas pedal, the engine drops back down to idle speed and then one or two seconds later the truck rpms are back up and accelerating like I wanted...
  4. R

    ecm fuse keeps blowing

    ok thanks fellas, ill start looking through my connections and wiring. another question...is it safe to drive my truck like this as long as I carry a few fuses with me for the time being? its my dd currently. could this cause any major issues that I should be worried about?
  5. R

    ecm fuse keeps blowing

    my ecm fuse blew a few days ago so I replaced it. the truck drove great and then blew the ecm fuse again just the other day. what could cause this/where should I start looking for this problem? electrical is not my area of expertise...
  6. R

    ecm fuse keeps blowing

    my ecm fuse blew a few days ago. I replaced the fuse and my truck ran great for a few days and then it blew the fuse again. what could cause this/where should I start looking to fix this problem?
  7. R

    fuel system diagnosis??

    we checked the fuse that is under the hood and it happened to be that it was not getting any power. after we found that out...we checked the ecm fuse under the dash and there it was...the ecm fuse was blown. so I replaced the fuse and she fired right up and ran like new.
  8. R

    Egr

    EGR- Exhaust Gas Recirculation. this recirculates a portion of the exhaust gasses back into the cylinders, and burns up the majority of the harmful emissions that were initially in the exhaust when it exited the cylinders the first time when it goes through for the second time. >>>> Emissions...
  9. R

    fuel system diagnosis??

    thanks for info! this weekend I will go through her and hopefully ill find out what my problem is! though it may not be the most interesting fix in the world, I will let you know what the problem is when I find it.
  10. R

    fuel system diagnosis??

    I recently rebuilt the transmission and the engine for my 1990 chevy k1500 (5.7L). She ran great for about 10 miles after I "thought" she was finished. my problem now is that she is not getting any fuel. so rather than just replacing the filter and pump right of the bat like I did last time (I...
  11. R

    Post your custom bumpers

    probably off topic, but where did you get your side mirrors? I would really like to get some of those for my truck!
  12. R

    internal transplant now a possible problem.

    I think they are to prevent chatter from shifting from 3 to 4. not sure...
  13. R

    internal transplant now a possible problem.

    so as was rebuilding my 700r4 I forgot to pay attention to a few little springs (they are in sets of 2s) while I was putting it back together. theyre about an inch long and I was wondering if I needed them? my old transmission, same one, didn't have them in it and the one in my rebuild video...
  14. R

    rebuild time!! again...

    the torque converter is ordered. I went with a 1650 stall from monster transmission
  15. R

    rebuild time!! again...

    there is not much to see inside the transmission since you already saw almost everything sitting on the work bench. maybe I will do a full write up if I decide to rebuild the other one too. here are some more pictures. she is almost put back together, all that is left is the front pump and the...
  16. R

    rebuild time!! again...

    I believe this is the forward clutch spring? compressor spring? not sure. but I broke it on the way out of the transmission. ordered a new one today so now I have to wait and clean parts for now.
  17. R

    rebuild time!! again...

    that was my reaction too. at least its just dirty so I can wash it up, no big deal there. everything else in it is fine as far as I know other than that clutch pack too. the rebuild kit came in the mail yesterday so when I get around to it I will start putting it all back together with new...
  18. R

    rebuild time!! again...

    hey guys! I started rebuilding the 700r4 that we have had laying in the garage for quite some time since the one in my truck went out again:waytogo: so....here we go! I purchased the tci maximizer rebuild kit. have yet to buy the torque converter (I am thinking the tork master 2000 from B&M)...
  19. R

    torque converter

    i need a torque converter for the transmission I am rebuilding. 700r4. looking for a 2000 stall. anyone know where to get a good one for a reasonable price?
  20. R

    1995 K3500, Fresh 4L80E...1-2 shift is too harsh

    my best guess would be that it needs more break in time. it should already be starting to calm down or shift normal by now though. I know that when I just rebuilt my transmission it shifted hard at first but once I put a few miles on it it calmed down. kindof a memory thing of how one drives...
  21. R

    1995 K3500, Fresh 4L80E...1-2 shift is too harsh

    how long have you had this transmission in your truck? how many miles have you put on the new one
  22. R

    getrag?

    well im heading out to check out the truck right now to drive it. yep it still drives but the engine is bad. so im going to look at it and check it out to see if I get it. ide be taking the axles and the trans and putting it into my truck
  23. R

    i need a new engine

    the stock engine has about 180-190hp and about 225ft lbs of torque...not much
  24. R

    getrag?

    since its coming from a parts truck, would I be able to swap in all of the other parts except the transmission and just put in a nv3500/4500?
  25. R

    i need a new engine

    wouldn't I be able to take the heads off of the engine I currently have though and swap them on???

Latest posts

Members online

Total: 1,385 (members: 41, guests: 1,344)

Forum statistics

Threads
64,562
Messages
1,396,682
Members
52,022
Latest member
Parttimepro

Share this page

Top