Search results

B
1994 yukon engine pinging knock detect sensor help?

Timing was set to 0 degrees TDC a few months ago after replacing intake manifold gaskets and the Yukon ran fine. It has started pinging recently on moderate to hard acceleration. I decided to check the timing again to make sure it was still set. After unplugging the tan/black wire I checked the...
- bigriver
- Thread
- Nov 15, 2011
- Replies: 0
- Forum: Engine Performance + Maintenance
B
1993/1994 Yukon power switch?

This is not my ride just a pic I found. Anyone know of a work around for the passenger side power window switch? There is no direct replacement for the switch that I can find. Didnt know if there was a work around on this i.e. some other vehicle the control button would fit on maybe. Dorman...
- bigriver
- Thread
- Aug 15, 2011
- Replies: 1
- Forum: OEM and Custom Interiors
B
Steering wheel did not re-center after front end rebuild?

Rebuilt the front end and replaced steering box. Steering wheel is off about 90 degrees to the right. Had the truck realigned and its still in about the same position. Best I could tell everything will only go back one way. Pitman arm on the steering box is grooved one way. Steering shaft is...
- bigriver
- Thread
- Aug 8, 2011
- Replies: 5
- Forum: Stock Suspension + Bolt On Kits
B
CV AXLE INSTALL TROUBLE?

1994 GMC YUKON 4WD Traded in old cv axles on some remanufactured CV axles from Napa and after 3 trips finally got a matching pair. Want do that again unless its a broke axle."Trouble" being when installing the remanufactued cv axles there hanging on the edge of the seal and folding them back...
- bigriver
- Thread
- Apr 27, 2011
- Replies: 1
- Forum: Axles + Brakes
B
1994 GMC YUKON WINDSHIELD REMOVAL?

Going to repaint the Yukon and the windshield is cracked. So instead of working around it I thought about removing for the repainting process and also to check for any rust damage. I have purchased a special tool to cut the adhesive around the windshield. There are (2) types of windshields one...
- bigriver
- Thread
- Apr 19, 2011
- Replies: 1
- Forum: Paint / Body / Detailing
B
FRONT AXLE SEALS 1994 YUKON

There are several threads covering this but not sure if what I was reading covered a 1994 1/2 ton year model. I have read where the driver side axle taps out with a hammer and the passenger side axle does not tap out but has to be removed via splitting the differential. Does the...
- bigriver
- Thread
- Apr 12, 2011
- Replies: 1
- Forum: Axles + Brakes