There's no way to pull the dash without unscrewing the harness on the outside fire wall.And 95 wiring is different from 96-99 so u will need to Swap wiring in the dash.
has any body had this code and fixed it. the light only comes on when on highway,i've checked the egr valve with truck running push up egr diaphragm the motor changes the idle plus it moves when i move the throttle by hand.
This is true what Gibson is saying one bad battery will make the other battery to drain especially if there's no isolater installed between the 2 batteries.
August 76 after you get the rear end swap check measurements I measured mine yesterday it's 1/4 off on one side I swapped this rear end years ago.
I didn't see any work parts I'll see if I can adjust it before I get a wheel alignment after replacing pitman arm
i think it's a allen or star bit can't remember i had to take mine apart to pull dash.just get a small mirror and a light to see what type of screw it is.
Did it have the subwoofer in it ? If so you can use it it is a 1.4 ohm sub so you will need a class d amp that is stable at 1ohm @350 RMS I had 12's but I took them out once I hooked
This sub up. I had another console and I took the sub out and using it in my dodge work van.
I call it (...
:) i got lucky and found this harness and a 99 HVAC at junk yard $28.00 BUT after i plugged it in all controls didn't work i looked closer it had burn
spot on circuit board went back to junk yard and took the board out another one working good now. i got to get L E D S for it also.