Recent content by MWMSilverado

  1. M

    1999 TAHOE BULD

    esterday I picked him up, the ac guy said that a new compressor is recomended the results of using old compressors is that they lock and lill extra stuff
  2. M

    Installing 95-02 C3500HD door handles on 99 tahoe

    I've seen that the 95-02 C3500HD came with the handles that you cam grab from up or down, the new style handles. THOSE I'm sure that both lock and open rods are different, not sure if keyhole. Someone did this mod? What you did? Do you know what parts and its PNs THANKS
  3. M

    1999 TAHOE BULD

    SO CHANGE OF PLANS I let tahoe on the AC guy because of leaks, it was parked since mid july with not that much starts so will be back on work because we will go to work zone on november or december so we are planning to rebuild old front end with nice parts and headlights and replace handle and...
  4. M

    Rear disc brakes

    oh nice
  5. M

    Throwing some BREMBOS

    I'm sure that this is one of that crazy ideas, but is it possible throw some brembo calipers and rotos or at least rear disc conversion on a 6 LUG tahoe
  6. M

    1999 TAHOE BULD

    HOE paint sucks, so I will paint it
  7. M

    1999 TAHOE BULD

    I just done assembling the door, works fine but HOE has to came back to work, pretty far from here, just a few days more and HOE will be back to work, clips ar ordered with some nice 60 pc trim removal tool, handles just when 2020 ends, HOE will be back, ad if i can i will facelift it with new...
  8. M

    1999 TAHOE BULD

    So I started repairing my 1999 tahoe, came pretty bad, some high milleage, ugly front end, doors thet don't lock, windows that are hard to open, piece made deas (PREVIUS OWNER JUST WRAPPED DASH), bented and loose rear trunk handle, hard to open but it starts and can give me home, but stuff is...
  9. M

    Door stuff

    So now I just repaired wiring and its nice, then I will rivet them and thats all till all parts arrive, it will give me home, lock doors and windows closed, I'm debating to buy or not the handles and the switch RH front
  10. M

    Door stuff

    So yesterday I repaired the actuator, not so bad but worse than I thought, both connector pins are on its spot, then i tested and I found a issue, actuator isn't working, disassbled him again and the wire was out, welded him and nice, reused the rubber cover of the LH oem one and its nice, now I...
  11. M

    Door stuff

    Yesterday I installed the DRV and PASS side, DRV side works nice, PASS side rod i found that is good! But the new actuator off PASS side its connector contacts slided in, wich sucks, but today i will remove it and repair it with epoxy glue, I will order CLIPS, RH SWICH, and HANDLES. It's crazy...
  12. M

    Project Daily Driver

    Nice job Already done the floorpan replacement?
  13. M

    Suspension Rebuild

    You have to buy OEM oe ACDELCO
  14. M

    Door stuff

    door wires are all crap looking, they are all nasty, the modifying to fit aftermarket speakers is ugly The wires are all like rat eaten, but its impossible to arat to get there so I think that is becuase it was all unclipped and t had friction with the sarp metal
  15. M

    Door stuff

    All clean, grease spilled in LH one. tomorrow i will finish installing DRV side
See more

Latest posts

Members online

... and 12 more.
Total: 1,725 (members: 62, guests: 1,663)

Forum statistics

Threads
64,558
Messages
1,396,558
Members
52,001
Latest member
Jamewild1

Share this page

Top