Recent content by chevy junkie

C
Rear not level

Well I probably tighten everything while it was hanging. I used shock extensions. And of course I didn't measure before the drop lol. So I guess I could loosen the bolts on the high side and see if that does anything
- chevy junkie
- Post #3
- Jan 4, 2024
- Forum: Lowered and Bagged Suspension
C
Rear not level

Hey yall. So I just did a flip kit on the back of my full size 1993 blazer and the passenger side is at least an inch higher. I did every thing the same not sure what could be causing it. Any suggestions or info would be greatly appreciated
- chevy junkie
- Thread
- Dec 28, 2023
- Replies: 3
- Forum: Lowered and Bagged Suspension
C
4wd to 2wd conversion

I have seen this and was thinking about doing that very thing. I thought I might like to go a little lower and its a lot easier to find lowering stuff for a 2 wheel drive.
- chevy junkie
- Post #6
- Sep 30, 2021
- Forum: Lowered and Bagged Suspension
C
4wd to 2wd conversion

Well I guess 6 lug it is. Thanks
- chevy junkie
- Post #5
- Sep 18, 2021
- Forum: Lowered and Bagged Suspension
C
4wd to 2wd conversion

I am going to switch my 1993 blazer to 2wd. I was wondering if the spindles from a regular half ton truck will work on the the torsion bar control arms? And if the rear end is the same width? Any information will be much appreciated.
- chevy junkie
- Thread
- Sep 15, 2021
- Replies: 6
- Forum: Lowered and Bagged Suspension