FastOrange
OBSless
Heads should have two small holes and intake gaskets will have be flat on one side and had two nubs on the other, nubs for in holes on heads
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Head gaskets go on dry and torque heads to proper specs and in right sequence, intake gaskets also go on dry, then run a thick bead of silicone from the corner of the intake gasket across the top of the block to the other intake gasket, repeat on back of block, put on intake, and torque down, also proper sequence for it.
I just remembered, check online, some head bolts might go into water jackets and need sealant.
Also, to really check what block u have, vortec blocks are usually 880 blocks and most TBI's are 638, should be stamped on rear of block and in the middle on the side on both sides.
Heads should have two small holes and intake gaskets will have be flat on one side and had two nubs on the other, nubs for in holes on heads
line wouldnt be that bad, if its way off cut it back and use some braided stainless and an AN fitting or two.