Well I finally got around to taking care of that irritating click click click noise every time I cycled the key. I searched and read everyones posts on it, watched a couple you tube videos. Took the glove box insert out, discovered the little bracket on the left side the door pivots on broken. I'll add that to the next pick and pull list. I gotta say, I've done lots of mechanical work for myself but that little top bolt proved to be one of the biggest pains in the butt ever! Lol. I did eventually get it using the piece of 3/8" gas line as an extension to make my 1/4" drive ratchet longer. And a couple breaks on my back because, well it just ain't a comfortable position to be in at my age! Finally got it out and discovered it was a 2 pin and the parts store had got me a 5 pin. I saw a pic of someone here who took the screws out and showed the stripped gear. So at 9:30 at night I said what the heck, I opened it up. Sure enough that little white gear was missing a few teeth. The new actuator was clipped together so I opened it up and popped both gears out to compare. Looked identical so I just swapped it out. Screwed it back together and ran it through a couple cycles and seemed good. So I put it back to center, then got lower screw and plug in but that top one was a pain. After much trial and error I was finally able to get that top bolt in and tightened up. A long pair of bent nose needle nose pliers saved me as I reached through the top and held the socket from loosening every time I tried to ratchet it back to get the next bite for tightening. It was definitely a test of my patience and a couple times I thought to myself, that dang clicking noise wasn't that bad after all! Once done, I turned on the key to a nice quiet actuator. Since I could see all three of them now I pressed buttons and watched which one was moving. Both the others are a piece of cake to change compared to the one I replaced. To me it looks like the one I changed works on max. I really didn't notice it moving when pressing the other buttons. The only issue now is the defrost seems like it's not opening. I did hi on fan and had vents, floor but hardly any air moving up to defrost. Any ideas? I left everything open so I can get that fixed as well.