Nitrobuzzard
Newbie
‘93 with 5.7 2wd
Ok so I’m checking the unit with my multimeter. At idle it’s setting around 1.2V, little high but no biggie. Problem is when I slowly go WOT voltage is nonexistent after 2.0V at roughly 30% throttle on signal wire. It remains nonexistent until I close the throttle off to around the 30% mark.
So is this showing a bad TPS unit? I checked incoming voltage and it’s sitting right on 5.0V. Ground wire checked good as well. TIA
Ok so I’m checking the unit with my multimeter. At idle it’s setting around 1.2V, little high but no biggie. Problem is when I slowly go WOT voltage is nonexistent after 2.0V at roughly 30% throttle on signal wire. It remains nonexistent until I close the throttle off to around the 30% mark.
So is this showing a bad TPS unit? I checked incoming voltage and it’s sitting right on 5.0V. Ground wire checked good as well. TIA