Kyle97GMC
NO SIR IT'S NOT A CHEVY.
I paid 400 for instalatilon and gave the guy my Flowmaster 40 series haha
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
sweet!
I'm going to be probably doing this myself, but what is the typical cost for a professional installation?
I know the OP complained of using a Sawzall to cut the bump stops out of the truck and I know his frustration. I burned a lot of blades trying to do this the first time. We have since started cutting them out of this bodystyle with a plasma cutter, but I do have a method for sawing them out for those that don't have access to plasma.
The bending of the blades happens right after you pass through the side of the bump stop mount and the tip of the blade hits the shock mount. If you are able to angle your saw about 45 degrees so that the tip is angled away from the shock mount while cutting from the rear you can cut quite deep without bending any blades. Should be able in 2 cuts, one from the front and one from the rear to cut clean through the bottom and about and inch in at the top. Now shove a pry bar in there and bend it out now you can lay the saw flat and cut the top section out from the bottom. Or simply work the material back and forth and shear the metal off through fatigue.
Now you can start the grinding. I'll try to grab some pictures of this process the next time I get one of these in the shop.
Our labor rates are $65 per hour. The typical GMT400 kit is about 10 hours, so can expect to shell out $650 for installation. However on the plus side, due to the age of these trucks the suspension components almost always need to be replaced for safe lift installation. So we typically replace the worn parts (ball joints, tie rods, pitman, idler arms, etc) at no additional labor cost. Its a fairly substantial savings considering the amount of labor involved just those components.
One trick I would recommend that I found, the sway bar end links on these trucks are a solid bolt with rubber on each end and sleeve in the middle. Its terrible design and wears out quite easily. Use Part # K750362 to replace it when you do your lift and you will be much happier. It is a greaseable Moog link that has joint on each end of it. This will allow for greater flex/life and easier installation than a stock replacement for a Chevy/GMC. Warning to you diehards that is a replacement part for a 2010-Up Ford F150. I found that part to work out of shear frustration trying to install the GM unit into the lower control arm.