I totally didn't think about that lift I always thought they where for 4wd. It's not that the body lift is causing problem I just think it looks weird. it shows too much IMO.
You must be registered for see images attach
when they dumped the "ultimate long travel" (more of a mid travel lift)they came out with this crossmember kit..... however if you go to fabtech's website, all they show is a 4 inch lift kit. RCD has a similar crossmember kit too claims with trimmind bumper, you can get 35" tires under her.
I agree on almost all body lifts that the frame hang looks bad, but at the same time ive seen plenty of incidents where the spacer goes through the bed, and that sucks!
There was a member on here who had/has (not sure which atm because he goes back and forth between wanting to lower it or keep it lifted but with a different kit) the Fabtech 7" long travel kit and has had multiple problems with keeping it aligned. So there may have been enough customers with that sort of problem that Fabtech discontinued it.
I have that same 7 inch lift kit, I dont have problems with alignment, when I originally bought it, the tie rod extenders were free ballin and it didnt take much to throw the toe off, so I bought some jam nuts and it keeps the toe alignment in place.
I would say when it cycles through the suspension the camber goes all over the place, but it does great in sand (for what it is) and ok in dirt for a bolt on kit. that coil bucket in the frame doesent do the 2wd guys any favors.