Gearheadmike
OBS Enthusiast
So i put a new 34" rad in my truck when i installed new engine i want to remove the clutch fan and shroud to clean it up a bit.
The truck is a 96 reg cab step side 2wd. I see the flex a lite kits for like $400+ but i'm not spending that much haha.
Did anyone ever use a junk yard fan setup that fits good? I know a 06 dual fan measures about 35" got to get height measurement still to see if its close to mine.
Wiring i plan on a temp switch in thermostat housing and a bypass toggle under dash for "in case" use.
The truck is a 96 reg cab step side 2wd. I see the flex a lite kits for like $400+ but i'm not spending that much haha.
Did anyone ever use a junk yard fan setup that fits good? I know a 06 dual fan measures about 35" got to get height measurement still to see if its close to mine.
Wiring i plan on a temp switch in thermostat housing and a bypass toggle under dash for "in case" use.