Need a hand. I'm new to the 5.7tbi (it's on my '94 GMC Sierra SLE - XCSB) and have had this truck for about 2mos now. I got some things to tune it up from summit. All was going well until I went to replace the coil. My coil is sandwiched between two brackets that are connect with a pin/post that goes through the holes on the bottom corners of the coil. That pin looks to be stamped into the one bracket and it is welded onto the other side. My problem is that both summit and the manufacturer are telling me I'm suppose to use the bracket and hardware I have! So I'm wondering, have any of you ever came across this? This is the part that I ordered:
http://www.summitracing.com/parts/HYP-4054/?rtype=10
Problem is I already had the cap and rotor installed from the kit before knowing that I'd run into this problem and I'd rather not have to take them off to return the kit.
Thanks for any help.
http://www.summitracing.com/parts/HYP-4054/?rtype=10
Problem is I already had the cap and rotor installed from the kit before knowing that I'd run into this problem and I'd rather not have to take them off to return the kit.
Thanks for any help.