I have looked around, and have not found it yet. Drilling holes in cigarette lighter.

[Caman96]

I put one of those on my Atv. This type.

You must be registered for see images attach

 

[Scooterwrench]

No way I'd give up my cigarette lighter.

 

[Caman96]

My 96’s has never been used.

 

[Hipster]

holy smokes. Why do it the easy way when you can do it it the hard way banging your head against the wall in the process.

 

[618 Syndicate]

holy smokes. Why do it the easy way when you can do it it the hard way banging your head against the wall in the process.

Exactly. Looking for a solution to a problem that doesn't exist...

 

[Hipster]

Exactly. Looking for a solution to a problem that doesn't exist...

A piece of plastic loaded on a drill press that's trying to be used as an endmill to open up a hole sounds like a broken plastic piece to me.

 

[618 Syndicate]

I already have the ashtray assembly pulled out, and have disconnected all three of the cigarette lighters. I am trying to use a drill press to widen the holes that are supplied by about 1/4 in. Is there anyway to do it, or am I beating a dead horse?

You're applying blunt force trauma to a previously expired equine.

 

[618 Syndicate]

A piece of plastic loaded on a drill press that's trying to be used as an endmill to open up a hole sounds like a broken plastic piece to me.

Uh, yeah.

 

[jus10inbrla]

You're applying blunt force trauma to a previously expired equine.

At that point we sent the equine to sale barn to be used as glue

 

[618 Syndicate]

At that point we sent the equine to sale barn to be used as glue

That's all it's good for.