Ekstensive 2 link bars are twisting??

[sowell]

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

My 2 link bars on my 94 silverado are twisting, i'm am tired of messing with it i'm thinking about bags over axle?, Do i still need to keep the bars in place just relocate the bags? I have a wishbone link also do i need to keep that? Or can i do a BOA with just 2 link bars for support?? I was gonna weld a piece of square tubing across from each other on this 2 link but my stock tank is in the way,I think this way would work just could never have side to side which all i want is up and down. How do u straighten bars back in place?? How do i add pics??

 

[DRAGGIN95]

Yes you can keep the 2 link intact and move the bags to BOA, do you have pic's of your setup?

 

[sowell]

I have to go to work, I will put some pics on here tomorrow,Thanks.

 

[Pierced]

I wanna see some pics too. I have Ekstensive kit on mine too and I have not had any issues with twisting. Is everything bolted down tight and bushings in ok condition?

 

[RPMGraphics]

i've heard if people having this problem before with 2 links. if the bag is off set more to one side & not gusseted properly the bars will twist.

 

[DRAGGIN95]

i've heard if people having this problem before with 2 links. if the bag is off set more to one side & not gusseted properly the bars will twist.

So have I, and lot's of other problem's as well, that's why I want to see some pics.

 

[Marcos]

Just going to have to notch the frame to center the bag on the bar.

 

[sowell]

i've heard if people having this problem before with 2 links. if the bag is off set more to one side & not gusseted properly the bars will twist.

So how do u straighten back out?? Pipe wrench??

 

[sowell]

Notch the frame??

 

[DRAGGIN95]

I agree with Marcos, since you have that type of wish bone and not much room for BOA you just need to cut and weld in a small notch in the frame to allow room to center the bag's on the bar's, I didn't realize that they were that far off of center it's no wonder the bar's are twisting.