Some pics to explain...
This is where my "Y Pipe" comes down from the manifolds and the first o2 sensor is in front of the cats.
You must be registered for see images attach
This is behind the furthest one of the cats (they are staggered, one slightly further back so they will fit)
You must be registered for see images attach
Which is then ran into this scabbed together H pipe
You must be registered for see images attach
Right before these two ty 22" glasspacks
You must be registered for see images attach
And in this picture you can see the exhaust I wanna put onto it, which I have about 7.5ft of straight 3" pipe with a MAGNAFLOW, not Flowmaster (thats my bad guys) and then the hump up over the rear end, and it was a drivers side exit but will probably just do a dump or cut, and flip it to the passenger side.
You must be registered for see images attach
MY PLAN is to Y it together infront of where the cats are now, (so where the exhaust comes down from the manifolds, and both curve back to the rear) with a 2.5" inlet to 3" outlet collector, and then run the 3" back and do something with the dump or side exit behind the pass wheel.
Yes, no? Opinions?
And if I can do it then, I will just ziptie the O2s up out of the way. There is no emissions in Alaska. And I will be completely redoing my exhaust probably next spring/summer.