Center console into a ice chest?

[ChrisAU]

I may be thinking to hard, but if you were to put a small (say 3/16") tube at the back, and run it through the floorboard, then run make a U with it and then point it back down I think it would be perfect, no drain required unless you wanted to keep water in the "cooler." The tube would keep a small amount of water at the bottom of the "U" which would insulate better than the console itself would, so no worry about hot air ruining your cooling capacity, and when the ice melts to a certain point the weight of the water will push itself out...leaving a small amount in the "U" for insulation. No plug to mess with.

Bourbon brings out the best in me.

 

[Rewind]

like a pea trap in a sink.

 

[ChrisAU]

like a pea trap in a sink.

Correct, its not thought of as a temperature isolator when used elsewhere though. It's used in sinks and toilets to keep smells out.

 

[smrr1]

hmmm how to send A/C to console?

 

[ChrisAU]

hmmm how to send A/C to console?

You already have a vent that runs below it...

 

[Bayou Bell]

hmmmm

 

[DR CHOP]

If your console has the removable insert , get it rhino lined

 

[capricefrk013]

LOL at the part # for the Motorcraft kit.

I have been wanting to do this for so long now and thats why I have been searching for a console.