-
-
HotrodZ06 replied to the thread Ls swap using only P0411 ECM, no black box.You don't piggyback the black box no matter what swap you are doing. The popular 0411 swap actually replaces the black box. -
HotrodZ06 replied to the thread Slip or no slip, what's normal?.It should move in and out with suspension travel as well as move in for driveshaft removal there may be a glob of grease or something...
-
HotrodZ06 replied to the thread Engine Died On Increased Throttle, Can Only Crank-No-Start In ‘99 Suburban 5.7L.I would start with just a new cap and rotor if that doesn't correct it then diagnose from there
-
HotrodZ06 replied to the thread Tire Pressure.None so far.
-
-
HotrodZ06 replied to the thread Losing drive.Is it full of fluid? Sorry to sound basic but I have missed that before.
-
HotrodZ06 replied to the thread Another AC problem.Is this on the 98 suburban in your signature block?
-
HotrodZ06 replied to the thread Tire Pressure.I run 40 in my non LT tires and 60 in my LT tires all 265/75r16.
-
HotrodZ06 replied to the thread 1998 K1500 Silverado 4X4 regular cab long box Frame Dimensions??.Would it be a possibility to find a front section of frame from the factory weld line under the front of the door forward, and weld in...
-
HotrodZ06 replied to the thread Engine Died On Increased Throttle, Can Only Crank-No-Start In ‘99 Suburban 5.7L.I would also check the crank sensor connector and wires, one of my friends truck died on him we pulled it to my house and found the...
-
HotrodZ06 replied to the thread No pressure rise.That's interesting will have to remember that, but the ones with the flare were gmt800s but had 4L60E's so thought it might be relevant...
-
HotrodZ06 replied to the thread No pressure rise.I've had a couple that no matter what we did it would flare in the 2-3 shift. One we fixed with a mass air sensor, the other the last...
-
HotrodZ06 replied to the thread New led third brake light...interior lights will not turn off.Was there an instuction sheet with the led one? I had the same problem and the new one had a sheet that said if you have this problem...
-
HotrodZ06 replied to the thread can you put a camaro intake manifold on a 5.7.I'm still interested in what engine the OP is working on and what intake manifold he is contemplating.
-
HotrodZ06 replied to the thread No pressure rise.That's a lot of good info for not being familiar lol.
-
-
Loading…
-
Loading…
Latest posts
-
-
-
Need help with a 97 5.7 liter not getting spark
- Latest: 1998_K1500_Sub
-
Key spins freely in driver door and won't lock or unlock.- Latest: Frank Enstein
-