-
-
Yeah, I looked. I wanted to post a video for you from YouTube but ran into a bunch of BS post. And I'm not 100 percent sure about this... -
InsanePyro1990 replied to the thread Yoke replacement.I appreciate it. YouTube is full of trash
-
here is a grate step by step write up, on how to do the rear end correctly. Thread 'GM 10 Bolt Rear Gear Install & Setup'...
-
When you replace the crush sleeve, you will need to pull the outer bearing anyway, to get the old crush sleeve out. Just look at it. If...
-
InsanePyro1990 replied to the thread Yoke replacement.So I don't need to pull the carrier? Just slide the shafts out? Can I use a digital torque wrench or do I really have to track down a...
-
InsanePyro1990 replied to the thread Yoke replacement.I drove it 10 miles or so
-
InsanePyro1990 replied to the thread Yoke replacement.No, I phrased that weird. I did brakes, seals and axle bearings. Even if I did them before I'm concerned I ruined them tightening the...
-
InsanePyro1990 replied to the thread Yoke replacement.So either way, I'm ripping it all the way down. Might as well do the bearings then just to be safe
-
If you need the cheapest route, you could replace that sleeve with a new crush sleeve but you would need to pull both axles, center...
-
InsanePyro1990 replied to the thread Yoke replacement.Ok, I wasn't gonna reply but since you're doubling down on this stupidity here we go. I just rebuilt the axle inward from the brakes...
-
InsanePyro1990 replied to the thread Yoke replacement.Should I replace them?
-
WHAT VEHICLE? Your K1500 Suburban? A ten-bolt is not worth the headache of dicking with a crush sleeve; which you're going to have to...
-
Your supposed to replace crush sleeve anytime the yoke is loosened/or tightened. Hopefully you did not burn the pinion bearings up.
-
If you over tighten a crush sleeve, then it must be replaced. You can only use a crush sleeve once. You must follow the proper procedure...
-
Replaced the yoke on my 10 bolt. I had no idea how much to tighten the pinion nut as it was taken off before I got to it. At first I...
-
-
Loading…
-
Loading…
Members online
- KCusick81
- Romac2702
- 0xDEADBEEF
- MyLast1
- Caman96
- Pinger
- PlayingWithTBI
- Supercharged111
- whiteaverson
- 2k2leenin
- prfixer
- Clean Stepside
- Joe Dirte
- man-a-fre
- KensKTruck
- strikk
- jtmcq23
- Stumpy
- Jsteel18977
- termite
- wcaldwell
- 99 escalade
- 98 Nitro
- Curtis21
- peteylen
- dradican83
- Andrews98
- fancyTBI
- evilunclegrimace
- Testostebro
- 12vC-obs
- GoToGuy
- Ando069
- hutch
- matthewtibbetts
- Jims437
- 92cc
- pandatruck
- cbrown210713
- Tintai
- tdawsey