Cb radios

[grampadirt]

Just a little Cobra but it works decent enough when off-roading so we can chat between trucks.The antenna is magnet mounted to the roof.The coax goes down under the transfer case shifter,under the front seat,out the rear door,up the door jamb(tucked in behind the door gasket)then on to the roof.Nothing fancy but it works for me.

You must be registered for see images attach

 

[Ruger_556]

PCTEL whip on the LH side directly across from the AM/FM. I like to keep a low profile... I hate the firestik look

You must be registered for see images attach

 

[great white]

Great white, how well has the mount on your shell worked for you. I have been looking at getting one but have concerns about damage to the shell from wind load on the antenna. To the op, mine is located same as yours. Seams to be the most common place.

I made mine, I didn't buy it.

There's a hole cut in the shell and the mount is made from 16G steel. It is folded and welded and extends out a couple inches on all 4 sides. Then it's sealed and RF bonded with braided straps.

So, no troubles at all.

 

[project 67 sub]

thinking about possibly putting one in my truck... since i have one i bought when i was driving a semi truck

 

[tardisguy]

roughly, what length coax does everyone use. i am going from a floor mount to the front stake pocket on the drivers side.

 

[K15 Blazer]

I really want one of the new HAM / CB combo radios and scanners.... theyre as much as CBs used to be... but CBs now are cheap as dirt cause no one uses them like they used to.
but on a road trip there is nothing better X) cell phones suck, and are (now) illegal to use when driving

 

[98_k1500]

Just a little Cobra but it works decent enough when off-roading so we can chat between trucks.The antenna is magnet mounted to the roof.The coax goes down under the transfer case shifter,under the front seat,out the rear door,up the door jamb(tucked in behind the door gasket)then on to the roof.Nothing fancy but it works for me.

You must be registered for see images attach

I love your mic hanger. I do the same thing. I have a CB/PA mounted in the same location, Whip antenna on the toolbox and PA under the hood in the spare battery compartment.

 

[grampadirt]

I love your mic hanger. I do the same thing. I have a CB/PA mounted in the same location, Whip antenna on the toolbox and PA under the hood in the spare battery compartment.

Thanks,it works pretty good.I rarely put anything in there,let alone a soft drink to bounce around and spill lol.

 

[lkfldredneck]

Tapatalk wont let me post pictures but my setup is a cobra 25ltd classic mounted on the bottom of the dash, battery op noise cancelling mic with the hanger mounted just below the control panels, AC control.

94 style dash

Sent from ******'s Cellular Device

 

[98_k1500]

Thanks,it works pretty good.I rarely put anything in there,let alone a soft drink to bounce around and spill lol.

Exactly. With it pulled out just a little like that, that little lip is the perfect size for the mic to hang on.