axle shifted toward passenger side after flip install...

[SunSetPrez]

In theory it shouldnt matter. But these type of parts aren't built to precision standards. If a part is off by 1/4" no biggie. It would be hard to notice. Then you add a part for a different company that might be off 1/4" also you're looking at a 1/2" and that's noticeable.

 

[drbizerk]

no matter how much I tightened the u bolts it wasn't tight enough to keep axle from spinning and creating a bad angle for the drive shaft. Beltech spring perch and shock extenders, Mcgaughys notch.....the rest of the parts I fabricated myself. I cut the perch off the axle like because I was planning on using the factory u bolts and plate mounting it on top of the axle. instead I got round u bolts, made my own plates with hole drilled accordingly for drive shaft alignment and welded the spring perch to the axle. ill post pics tomorrow

 

[drbizerk]

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[drbizerk]

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[drbizerk]

You must be registered for see images attach

the homemade plate with offset to scoot axle toward the rear....

 

[drbizerk]

sorry about the sideways pics x 2