Taz069
OBS Enthusiast
Next a few of the little engine that can
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
@roadtrip never got a picture of my motor #'s here they are. After rolling the dice in this build. Mr.Pilcher had to change the 4-bolt caps. Seeing the ones I received weren't for the block. All good he fixed itHi Taz069,
Here's 3 photos showing the clearance 'hot spots' when you stroke a SBC. One thing to keep in mind is that you can have clearance issues with either 5.7" or 6" rods:
SBC oil pan rail + bottom of bore ground to allow adequate clearance for connecting rod nut swinging past at 100 times per second at 6K rpm (close up)
You must be registered for see images attach
(Credit: Motortrend SBC stroker build article -- recommended read: (LINK)
Same as above, big picture view.
You must be registered for see images attach
(Credit: Motortrend SBC stroker build article -- recommended read: (LINK)
But even after clearancing the oil pan rail and the bottom of the bores for the stroker rotating assembly,
we still aren't completely out of the woods yet. The bigger stroke = parts moving in a bigger circle the
full 360° of rotation, so now we also have to check to make sure we don't whack those extra-tall cam lobes we
also decided upon with the connecting rod's bolt heads?
Note: Due to con rod vs cam lobe (firing order) phasing, most lobes successfully 'timeshare' the same space, but there's a couple that want to clash/crash. (!)
You must be registered for see images attach
(Credit: Chevrolet Power Service Manual, 5th edition) Note also that this engineering drawing is showing a big lobe cam versus a 3.48" (350ci) stroke. 383s = extra caution warranted!
****
By the way, from what you mentioned previously it sounds like you are using the 3970010 4" bore, 4-bolt main block.
I've used that same block for builds in the past. (including 383s!) Properly set up, these blocks are a proven-good
foundation for a build like yours.
The bottom line is that you are officially trying to fit 11-lbs of displacement into a 10-lb bag.
It can be done, but attention to detail is what's gonna make or break this build. No doubt
your machinist has several of these 383s under his belt.
Hope all this helps when you are talking to your machinist. Just asking him how did he
ensure that your chosen cam and rods don't interfere using the 3.750 stroke crank
(small base circle cam? capscrew rod? other?) ...will let him know that you better
appreciate what he's put together than most stroker 383 customers, if you know what
I mean.
Can't wait to see photos of this engine back into your truck & running. Good luck!
@roadtrip never got a picture of my motor #'s here they are. After rolling the dice in this build. Mr.Pilcher had to change the 4-bolt caps. Seeing the ones I received weren't for the block. All good he fixed it