“Government cheese” how it started vs how it’s going

[Government cheese]

So the drivers side is done, I had to slice of pieces of the front flare get the plastic snaps through. I think it was there to push the flare out further but the only other way that they are held on is 3m tape up top and that I felt like would cause an issue with them pulling. I have to do the passenger side front tomorrow just didn’t feel like doing the mod work to the other one yet. But here are some photos. It will need to come down some.

 

[Government cheese]

It took a little modification on the front flares, they have a little plastic that pushed them off the fender in the front and rear, honestly they are probably there so the flares can push off the fender further but that didn’t really work with how the back ones mounted, I zip wheeled them off and it mounted right up. I think it’s settled in well enough, i may lower the rear a bit

 

[Government cheese]

I also decided to cut off the cheese part, if I had made the sticker mirror the other where the cheese faced forward like it did on the drivers side then maybe, but all and all I am happy with the in general look. Definitely meaner looking with the wheels and flares

 

[Stumpy]

Well done. A 4/6 drop, and it'll be looking right.

 

[Tommy1234]

Nice truck

 

[618 Syndicate]

They have a section here but some nice ones are peppered into the show

That grey truck in the first pic was at Southeast Truck Nationals. It's effin sick.

 

[Orpedcrow]

I love this truck. Love seeing work trucks being taken care of after retirement lol. There’s a CCLB dually at the school district in the next town over same teal green as my ECSB. I’m just waiting for it to “retire”