driveshaft

  1. A

    1997 GMC K1500 Z71 Front Drive Shaft orientation

    Hello, Vehicle: 1997 GMC K1500 Z71 Does the front driveshaft have a certain orientation to be properly installed? It is telescoping, does the telescoping end go near the front of the vehicle near the front differential or does it go to the rear side near the transfer case? Also, does...
  2. Buick

    99 Suburban Highway Rumble

    Hey Guys, been a LONG time lurker on this forum, but I'm finally at wits end with my '99 K1500 Suburban. At highway speeds, between roughly 65-75MPH, there is a pronounced low frequency rumble. It is pretty loud, but difficult to determine where on the vehicle its coming from. Along with the...
  3. CBenZ71

    Rear Drive Shaft

    I have a 1999 K2500 Crew cab short bed. The rubber on my center support bearing is toast, so I need to replace it. How the heck do I get these two pieces apart so I can press the bearing off?? The rubber/metal cap just spins but it seems to be stopping the splines from pulling out when I try to...
  4. K

    89 K1500 Front wheel bearing/CV shaft upgrade

    There are two different options of wheel bearings dependent upon standard vs heavy duty suspension. My son and I have been rebuilding a standard cab swb K1500 with standard suspension and brakes and upgrading it as we replace parts. My question is if we have to replace the front drive shafts...
  5. A

    Driveline Questions

    I have quick question and I know there are some very knowledgeable people on this site who may be able to help me out. I installed an LS in my 1995 2wd ECSB and also installed a 00+ 4l60e which is 3/4 of an inch longer and I want to put on 2 inch lowering shackles for the rear. My question...
Top