carburetor

  1. BigTater

    Lawsuit - Back From The Dead

    Been meaning to make this writeup for well over a year now... Introducing "Lawsuit", my 1994 K2500 Extended Cab that was left for dead when I first saw it. Bought new in 94' by a family friend for use on their horse ranch in Montana, this truck later spent a few years working in a Michigan...
  2. H

    Got this TBI to carburetor adapter online. It didn't work out to well...

    Got a plastic TBI to carburetor adapter, as I replaced the original intake due to a certain pipe thread port being too damaged to be used without leaks. The engine ran kinda rough after driving several miles, which I then checked the adapter for any issues. I took it off because I was hearing a...
  3. hilly101111111

    TBI To Carb Swap With Adapter Plate VS Intake

    Im looking to carb swap my TBI 350 and im wondering does anyone have experience with keeping the tbi intake and just using an adapter plate on top and maybe swaping in like a Holley 2 Barrel or something. Thoughts >? I don't really want the computer to run my truck anymore nor do I really feel...
  4. Warrick454

    good intake and carb for 350 vortec

    Got a bone stock 95 350 I’m gonna put vortec heads on and carb swap just want some advice on a good intake and 4 barrel carb
  5. U

    Carb/fuel advice help

    I’m planning out a 383 stroker build and am aiming for about 400hp at the flywheel. it is a 1990 regular cab step side 5 speed manual. I’m aware I’ll have to upgrade the tranny to a beefier one but I plan to get the motor running first and drive it super easy until I have more money for a...
  6. V

    1997 c1500 5.7 carb

    So I have a 96 c1500 that has the stock trans but I’m putting a carbureted engine into the question is will the trans work without all the electronics on the engine and if not for anyone that has what did you buy to make it work
  7. seth9199

    97 chevy to make transmission shift with carb

    hey guys im trying to do a build out of a 97 chevy and i need to figure out how to make the trans shift. with the original pcm. i know i need a rpm and a trottle pos signal but dont know what wires from the harness i need to put into the rpm rear out swaping in a carb and a double roller so ckp...
  8. CJ Tanner

    Carb swap wiring help.

    Hey guys I’m new here and looking for a little help on carb swapping my pickup. It’s. Vortec 355 with a nv3500 5 speed. Fuel pressure regulator is installed but I’m needing some help on getting the fuel pump to kick on. Thanks guys.
  9. Matthew40566

    Carb problems.

    Hello, Last December I picked up a 1988 GMC C1500. It has a recently swapped and rebuilt 5.7 with a 700r4 trans. The engine was rebuilt with a Holley 4175 that's missing most of the choke components. Now that it's starting to get cold it takes about 45 seconds to start and has to be warmed up...

Latest posts

Staff online

Members online

... and 6 more.
Total: 2,869 (members: 56, guests: 2,813)

Forum statistics

Threads
77,810
Messages
1,640,248
Members
80,492
Latest member
subven69
Top