Search results

  1. B

    drive belt size

    What size drive belt do I need for a 1998 K1500 5.7L with A/C? I saw a few options on rock auto depending on the size of alternator. How can I tell what amp my alternator is?
  2. B

    What is this orange cable that isn't attached to anything?

    Sent from my ASUS_Z00AD using Tapatalk
  3. B

    No acceleration at beginning of drive

    When I start driving either when the car is cold or warm, the truck hardly responds to the throttle. I can put it to the floor and no acceleration occurs. After several seconds, the truck starts to respond and runs fine. I took it to the Chevy dealer and they said it was due to a gummed up...
  4. B

    vibration at hwy speeds

    1998 K1500 5.7L Truck vibrates (not terrible but annoying) most noticeably at 60-75mph. I also notice it when I let off of the throttle to let it coast (again, at hwy speeds). Any Ideas? It is not the front end as I had the whole front end replaced (not because of this issue).
  5. B

    engine block heater location

    Where would the engine block heater cord be located (if I have one) on a 1998 K1500 5.7L? Going to be -20 in the morning w/ -55 windchill.
  6. B

    Rear main oil seal

    According to a couple shops, my rear main oil seal should be replaced. It isn't too bad of a leak, just something that should be done when possible. I am thinking I'll get it done on my next oil change. From what I have researched, it is a one/piece seal & requires removing the tranny. Both...
  7. B

    Hub assembly bolt

    Stripped hub assembly bolt. How do I get it outa there? Sent from my RM-860_nam_usa_100 using Tapatalk
  8. B

    Bought 1998 K1500

    5.7 350 Vortex 99,000 miles. Would like to do a coolant flush. What kind of coolant should go in? What oil/filter? Would also like to do a tune up, what parts do I need? Sent from my RM-860_nam_usa_100 using Tapatalk
  9. B

    fan won't work on high

    My blower fan won't work when it is on the highest setting, it will work on the 3 lower settings though. I am thinking about maybe trying to replace the blower motor resistor, any thoughts?
  10. B

    weak air coming from dash vents

    When I have the dash vents selected for the HVAC system, the air coming out of the vents is really weak & also blows out of the floor vents. Shouldn't the floor vents be blocked off? I can hear the blower motor is really working (it is new).
  11. B

    new corner lights

    How am I supposed to attach these new corner lights? I was thinking it should have come threaded w/ a nut or something...
  12. B

    sway bar link

    I am trying to replace a missing swaybar link. As you can see in the second picture, there is a bar in the way so I cannot get a good angle...any tips?
  13. B

    Brother is at army, taking care of his truck

    This truck has been in our family since new. It runs great. Just performing fixes and tune up tasks. I replaced the following a week ago: cap and rotor, plugs and wires, and ignition coil. The intake gaskets were leaking a little so I had a shop replace the gaskets for a reasonable $350...

Latest posts

Members online

Total: 1,048 (members: 16, guests: 1,032)

Forum statistics

Threads
64,581
Messages
1,396,969
Members
52,049
Latest member
fentanyl

Share this page

Top