Recent content by Teal97k1500

  1. T

    stacks on a gas truck?...

    okayyyyy sooo i really wanted a diesel, but i got to good of a deal on my 97 k1500 350, which has a 6" RCX rough country lift on 35s that being said i still really want the diesel look, and i also happen to own a set of 6" angle cut stacks and y pipe.. now my truck current has crappy true...
  2. T

    Thrush Glasspacks

    THANK YOU!!! iv been pulling my hair out trying to figure out why im getting to lean bank 1 and bank 2!!! my truck came with true duals with thush 25'' glass packs on it, which i can NOT wait to remove....... haha sorry to thread jack but thanks blazer i had no idea this would cause the o2...
  3. T

    Pedal goes to floor when running, cant for the life of me figure out why! please help

    i dont and im running out of money, iv already spent over $300 this weekend in brake parts and a few things the truck needed well we have a somewhat decent pedal now today i adjusted the back brakes up tight, parking break still is kinda y, altho it was before all of this.... i also...
  4. T

    Pedal goes to floor when running, cant for the life of me figure out why! please help

    alrite well to start its a 1997 Chevy K1500 Z71, 350 vortec, 4l80 trans swap, 4x4, 6' RCX lift on 35s. well i bought it with a bad wheel cylinder thus my pedal going to the floor, he had been driving it like that for some time, i had to drive it to work for a week before fixing it. SO...
  5. T

    bolt on performance

    depends where you get them, i get most thinsg through summitracing.com or southbayinjectors.com
  6. T

    Supercharge my vortec 454

    as far as your stock gears go... that depends... what do you plan to do with the truck what type of driving/racing/offroading are you wanting to do? what are even are your stock gears? is it a 10 bolt or a 14 bolt? NEED MORE INFO to give ya a proper answere buddy.
  7. T

    Supercharge my vortec 454

    www.summitracing.com
  8. T

    4 Corner Mod???

    are upper and lower corners the exact same ones? i would like to do clear ones top and bottom and smoke them
  9. T

    4 Corner Mod???

    wow that was fast thanks guys, sorry im a new to this forum still trying to figure out how it all works, it a bit differently layed out then the forum i used for my camaro :) thanks again everyone im doing this as soon as my truck gets back from the trans shop
  10. T

    4 Corner Mod???

    hey all a gmt400, excuse me if this has been asked 1,000,000,000 times but is there a write up on how to do the 4 corner mod? i really wana do this on both my k1500 and my 454 ss c1500.....
  11. T

    NEWB! help finishing 4l80e swap

    maybe what i should be asking is if there is a how to thread on the 4l80e conversion beside the article on it
  12. T

    NEWB! help finishing 4l80e swap

    if just going back to stock is easier i have the original 4l60e and electric t case, this truck isnt seeing off road use so im not TOO worried about strenght, but it will see a small car trailer with my camaro on it from time to time, and a set of 35s the 38s must go
  13. T

    NEWB! help finishing 4l80e swap

  14. T

    NEWB! help finishing 4l80e swap

    also it has a 6" rcx rough country lift on 38s (looking to get 35s and sell the 38s but ill do that in the classified later)
  15. T

    NEWB! help finishing 4l80e swap

    first of all, hey all here at gmt400! got a good recomendation to come here from one of your fellow members ok so anyway let me get started, its a 1997 K1500 ext cab short bed 350 vortec 4l80e (swap half done when purchased) stock 10 bolt rear but both have new caries with clutch...
See more

Latest posts

Members online

... and 10 more.
Total: 1,662 (members: 60, guests: 1,602)

Forum statistics

Threads
64,461
Messages
1,394,614
Members
51,722
Latest member
phillies11793

Share this page

Top