Recent content by shelbyt.67
-
S
Slight howling noise from rear differntial
Pop your diffy cover and check your ring gear. There is a magnet on the cover. Check for metalic material. A bad pinion bearing will knock you ring gear outa whack and cause excessive wear. This will give the howl.- shelbyt.67
- Post #2
- Forum: Axles + Brakes
-
S
Steering knock?
Check your upper control arm bolts. If one is loose it will pop or knock while turning.- shelbyt.67
- Post #12
- Forum: Stock Suspension + Bolt On Kits
-
S
Remote Mount Filter for 6.5
http://www.gmt400.com/forum/showthread.php?17277-REMOTE-OIL-FILTER-INSTALL-FOR-5-7-TBI&p=440557&viewfull=1#post440557 Summit should have one for the 6.5- shelbyt.67
- Post #2
- Forum: Engine Performance + Maintenance
-
S
Bull dog stance
I think u may be lookin fer a set of wider wheels with a larger offset than stock. The lifting by itself doesn't give a wide stance.- shelbyt.67
- Post #23
- Forum: Stock Suspension + Bolt On Kits
-
S
new guy with a fun project!
Welcome. Thats quite the moniker. ;p- shelbyt.67
- Post #14
- Forum: Introduction
-
S
XJ Steering Shaft Upgrade (88-94 Trucks) 95+instructions on page 31
Reread the first post and the first two pages. There are links to 97+ mods and posts affirming use on body lifts. I updated the original post to reflect the use of Grand Cherokee, Limited and Astro van shafts.- shelbyt.67
- Post #156
- Forum: Stock Suspension + Bolt On Kits
-
S
Shelbys Z71
Mine fit the original grommet size. I did replace the grommet due to age. IIRC the grommet hole is 3/4"- shelbyt.67
- Post #138
- Forum: Member Trucks
