rpoL98's latest activity
-
RDon't drive it until you follow Nick's advice. If your TV cable is too loose you will burn up your transmission.
-
RCheck out the sticky in the transmission section, 2nd one down. @NickTransmissions did an excellent write up on how to set the cable...
-
RSounds like you didn't follow a couple essential steps: TV Cable adjustment valiation via pressure testing and servo travel check to...
-
RA lot of the time, the diaphragm inside the horn gets rusty. It’s a metal disc that vibrates very fast; with the tuning screw adjusted...
-
RThe first thing I do when I buy sets is shake the holy **** out of them. If it sounds like a miraca then it’s likely it’ll quit working...
-
RTap on intake manifold or cylinder head with small hammer. Listen for engine RPM to decrease; or watch the timing retard using a timing...
-
RLate to the game, but the issue of PINGING got my attention. Most posts here and there, only talk about the EGR valve. It is a key...
-
RThis is how I tested mine after replacing a bad G80
-
RrpoL98 reacted to NickTransmissions's post in the thread 700r4 4x4 transmission problems!!! with
Like.
What? The 700R4 needs a throttle valve cable hooked up, set up and adjusted properly. There's no such cable or provision on a 1993... -
RI just checked. There’s 20 threads of information on LS Swap. I would start there, it’s probably already written.
-
RrpoL98 reacted to NickTransmissions's post in the thread Can a Th700r4 be used for towing? with Like.
You can build a 700R4 to tow/haul/work but is it going to be as cost effective or as durable/capable as a TH400 or 4L80E? Nope. Also...
-
RI don't think that would be the reason I chose twins over a big single, but to each their own.
-
RBecause true duals just plain sound better vs a single pipe.
-
RI like running twin turbos to keep true dual exhaust.
-
RReally simple exhaust too. I left the turnouts short but just thought about it, I need to move them to clear for the Assassin Bars now. :(
Staff online
-
df2x44L60E Destroyer -
kennythewelderOfficially Retired, B31-3 (6-G) certified welder.
Members online
- Eeyore79
- Caman96
- Laredo
- BennyGuajardo
- twebuh
- 95YardArt
- IndexOf0
- kenh
- movietvet
- slow_c1500
- df2x4
- dgalando
- Orpedcrow
- Kchevys
- Carlosm86
- nickc2500
- Tadge
- ol-Betsy
- Jskingry
- Remodelmaster
- 454C2500Longbed
- Eveready
- Alteca
- Drunkcanuk
- ljenny910
- Ampedracing
- Supercharged111
- the_elegant_fox
- Nephrodoc
- 90gmcsierraL59
- SAATR
- cgreppi
- curzondax79
- Rickslick82
- 1997SierraExtreme
- Vic327
- Jason Warrum
- kennythewelder
- Ironroad9C1
- BNielsen
- Jolson091
- Nad_Yvalhosert
- 99xcss4
- Erickbarba692
- Joshday
- StevenGomez123
- Das Hatt
- Dravec
- Gnorth15
- 83GMCK2500