Thanks for the replies guys I put my old master flow sensor back on and the truck runs OK again now I’m only throwing the code P0410 for secondary air injection System?
I have a 454 Vortec and it was throwing a code P0401 “Exhaust gas recirculation flow insufficient” and P0410 Secondary air injection system” I clean the EGR valve and made sure the EGR port wasn’t clogged with carbon... did not solve my problem. The u threw a new EGR on to make sure. Wasn’t it...
The only one on eBay is the wrong one and I couldn’t find one at the junkyard they’re all for 350 or 454s with the shorter radiators in the 2 Wheel Drive models
Been trying for so long to find a shroud but my truck is a 2000 K3500 with a 7.4L so the fan shroud doesn’t go as deep as the 350 and also I have the taller radiator so the original shroud has to you over it I’ve been ordering them online but they’re all for the 350 and shorter radiator what the...
The ones you attached from Summit racing or for a different distributor. I will look into see if I can put 45 on my old plug for now thank you guys for the response
My 454 Vortec has C.A. legal short-tube elderbrock headers and there is not enough room to clear the big long boots on the original plug wires they have to curve in this leaning on the headers and getting burned up even with fiberglass sleeves I'm trying to find a good set wires that are 45...
I can’t find any. I called summit racing and they didn’t have any.
I have the CA legal eldabrock short tube headers. Even the kind you make I couldn’t find the straights for the dist Side for the 96-00 vortec 454.
My Drawtite bug guard broke. The vent shade one I order off eBay was way smaller and slimmer. Does anyone know of a bigger bug guard? I can’t find any new draw-tite ones.
Thanks!
My 454 Vortec has short tube elderbrock headers and there is not enough room to clear the big long boots on the original plug wires they have to curve in this leaning on the headers and getting burned up even with fiberglass sleeves I'm trying to find a good set wires that are 45 degrees on the...
By the way the truck is a year 2000 obs if that matters also wondering if I have to upgrade the master cylinder? And if so does anyone know if it's a direct bolt-on?
does anyone know if I can upgrade my srw K3500 front disc brakes to dually brakes will the rotors and calipers work and be an upgrade?
Thanks I have researched but have only found half ton upgraded to 3/4 ton and 1 ton but not any srw to drw brakes
So stock on my 2000 Chevy K3500 there is six bolt holes that mount the hitch, four holes on the frame and two holes on the rear bumper brackets. But when I put the body lift on I got the rear bumper lift brackets also and they don't have the two tabs with holes for the hitch like the stock ones...
Please help! So my 2000 K3500 with a 7.4l Vortec was squealing found out that the tensioner doesnt apply tension anymore so went to get a new one found out that they are not in production anymore so found one on eBay where they custom make a different one to fit the 96 to 2000 7.4 vortec by...